lightads | 2 months ago | 7 comments | 1 like | 251 views
mohkamil likes this!
Added a picture layer - Style Cylinder.
The Morphing Stage property controls cylinder bend/wrap amount but only left and right, eg. to wrap around an upright tree. How do I control the top and bottom wrap/bend to wrap around a horizontal pipe?
Thanks, I tried Plane2Roll but it only rolls from one side, not evenly like the cylinder style does.
Also tried Plane2Cylinder but it only wraps in the wrong orientation.
lightads, 2 months ago
I would:
-use a picture layer
-select the CYLINDER style
-set the ROTATION prop to (0, 0, 90)
-animate the MORPHING STAGE prop
michiel, 2 months ago
Perhaps adding a feature where the Morphing Stage 2nd slider adjusts the other orientation?
lightads, 2 months ago
This will cause confusion because the 2 sliders can't be used at the same time. Adding an FX ROTATION prop to the Picture\Plane2Cylinder effect is maybe a better way.
michiel, 2 months ago
Could you please test this effect? I think it does what you want when you set the FX HORIZONTAL AXIS prop to 1:
michiel, 2 months ago
Comment to this article
More by lightads
About lightads
Using 3D BluffTitler to give me the edge in my video editing :)
137 articles 105.4K views
Contact lightads by using the comment form on this page or at filmingphotoguy@afrihost.co.za