lightads | 4 years ago | 1 comment | 734 views
Is there any reason why the Z axis for new Container layer is set to 500?
After adding elements and then I rotate it's off center. So I always set X Y Z to 0 before I start but sometimes I forget.
Because the default camera position is set to (0,0,0). Placing the container at (0,0,500) makes it immediately visible.
I think your question is about a container inside another container. In this situation, the position could, indeed, better default to (0,0,0). Thank you for your request!
michiel, 4 years ago
Using 3D BluffTitler to give me the edge in my video editing :)
135 articles 103.1K views
Contact lightads by using the comment form on this page or at filmingphotoguy@afrihost.co.za